To help every rider find their fit, we’ve created three different all-carbon extensions for the VukaAero and VukaClip. Straight extensions will get you as low as humanly possible. Chicanes are ideal for mid-range speed and share their S-bend shape with the VukaShift. Ski Tips offer long-haul comfort.
All Vuka extensions can be shortened by almost 100mm from their standard 335mm length to accommodate any bike configuration including ITU-legal racing. Internal cable routing for aerodynamics and ergonomics. Approximately 100g per pair.
Guidelines For Cutting The Extensions
- The extensions are marked on the underside in 1cm increments with half centimeter increments shown with smaller lines. A minimum of 3cm of extension must be inserted into the VukaBullet body to avoid damaging the extensions. This means that a minimum of 6 marks (3 large and 3 small) must be inserted into the bar after the bars are cut to length.
- If more than 4cm of extension need to be removed, we recommend removing in 2-3cm increments to avoid overcutting of the extensions.
- The extension should be wrapped in masking tape at the point where it will be cut and cut with a composite or FRP specific hacksaw blade. The masking tape will help ensure that the cut is clean and no jagged fibers lift off of the part.
Warning – do NOT cut anything from the front end of these extensions.
| Weight |
101 (+/-3)g |
| Length |
max 335mm, min 265mm |
| Diameter |
22.0mm +0,05mm -0.15mm |
|
|
| Angle from Vertical |
50 Degrees |
| Inside Length to Start of Bend Without Cutting |
207mm |
| Inside Bend Length |
92mm |
|
|
| Inside Length to Start of Bend Without Cutting |
207mm |
| Rise from Horizontal |
40mm |
